LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0243 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0685-P0687, P0689, P0690, P1682, P16A7, P16AF, or P16B3 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Relay Test

  1. Ignition/Vehicle - Off
  2. Remove the component: KR75 Engine Controls Ignition Relay
  3. Test for 70 to 110 ohms between the test points: Component terminal 85 & 86
    • If not between 70 and 110 ohms 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If between 70 and 110 ohms 
  4. Test for infinite resistance between the test points:
    • Component terminal 30 & 85
    • Component terminal 30 & 86
    • Component terminal 30 & 87
    • Component terminal 85 & 87
    • If less than infinite resistance 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If infinite resistance 
  5. Connect a 3 A fused jumper wire between the test points: Component terminal 86 & B+

    Connect a jumper wire between the test points: Component terminal 85 & Ground

  6. Test for less than 2 ohms between the test points: Component terminal 30 & 87
    • If 2 ohms or greater 

      Replace the component: KR75 Engine Controls Ignition Relay

    • Go to next step: If less than 2 ohms 
  7. All OK.
scientia non olet · About LEMON Manuals