LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Controls And Fuel - 1.6L (LWC) - DTC P0243 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0351-P0354, P2300, P2301, P2303, P2304, P2306, P2307, P2309, or P2310 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Circuit/System Testing must be performed before proceeding with Component Testing.

  1. Ignition/Vehicle - Off
  2. Remove the appropriate component: T8 Ignition Coil - Leave the electrical connector connected.
  3. Install the special tool: J-26792  Ignition Spark Tester
  4. Engine - Running
    5. NOTE:

    An erratic or weak spark is considered a no spark condition.

  5. Verify there is spark at the tool.
    • If there is no spark 

      Replace the component: T8 Ignition Coil

    • Go to next step: If there is spark 
  6. All OK.
scientia non olet · About LEMON Manuals