LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Power Steering System) >> Repair Instructions >> Power Steering Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Battery Negative Cable Disconnection and Connection - Disconnect
  2. Raise and support the vehicle. Lifting and Jacking the Vehicle
  3. GM4247052
    WARNING:

    While engine is operating, the exhaust system will become extremely hot. To prevent burns avoid contacting a hot exhaust system.

    Electrical Connector(1)@Power Steering Assist Motor - Disconnect

  4. Clip(2) - Remove
  5. GM4247051

    Remove the 2 clips (1) from the power steering wiring harness bracket (2).

  6. GM4247053

    Fuse Block Cover(1) - Remove

  7. GM4247054

    Nut(3) - Remove

  8. Nut(2) - Remove
  9. Remove the power steering wiring harness (1) from the vehicle.
scientia non olet · About LEMON Manuals