LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Power Steering System) >> Repair Instructions >> Power Steering Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4247054

    Install the power steering wiring harness (1) to the vehicle.

    2. CAUTION:

    Fastener Caution

  2. Nut(2) - Install and tighten 9 N.m (80 lb in)
  3. Nut(3) - Install and tighten 9 N.m (80 lb in)
  4. GM4247053

    Fuse Block Cover(1) - Install

  5. GM4247051

    Install the 2 clips (1) to the power steering wiring harness bracket (2).

  6. GM4247052
    WARNING:

    While engine is operating, the exhaust system will become extremely hot. To prevent burns avoid contacting a hot exhaust system.

    Clip(2)@Power Steering Assist Motor - Install

  7. Electrical Connector(1) - Connect
  8. Battery Negative Cable Disconnection and Connection - Connect
scientia non olet · About LEMON Manuals