LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Automatic Transmission - 6T45 (MH7) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P1761 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following system/component: Serial Data
    • If a related DTC is not set 
    1. Ignition/Vehicle - Off
    2. Replace the component: Q8 Control Solenoid Valve Assembly
    3. Operate the vehicle within the Conditions for Running the DTC.
    4. Verify the DTC does not set.
      • If the DTC sets - Replace the component: K9 Body Control Module
      • Go to next step: If the DTC is not set
    5. All OK.
    • Go to next step: If no DTC is set 
  3. All OK.