Circuit/System Testing
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the condition does not exist:Incorrect pressure - Refer to:Line Pressure Check , & Solenoid Valve Pressure (Gen 2)
- If a condition exists
Refer to:Fluid Pressure High or Low
- Go to next step: If no condition exists
- If a condition exists
- Ignition/Vehicle - Off
- Remove the component: Q8 Control Solenoid Valve Assembly
- Verify the procedure/test passes. - Refer to:Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
- If the procedure/test does not pass
Replace the component: Q8 Control Solenoid Valve Assembly
- Go to next step: If the procedure/test passes
- If the procedure/test does not pass
- Refer to:Diagnostic Fault Information