LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Automatic Transmission - 6T45 (MH7) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P071D >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: S109 Sport Mode Switch
  3. Test for infinite resistance between the test points: Signal terminal 3 & Ground terminal 1 - The switch is in the open position.
    • If less than infinite resistance 

      Replace the component: S109 Sport Mode Switch

    • Go to next step: If infinite resistance 
  4. Test for less than 2 ohms between the test points: Signal terminal 3 & Ground terminal 1 - The switch is in the closed position.
    • If 2 ohms or greater 

      Replace the component: S109 Sport Mode Switch

    • Go to next step: If less than 2 ohms 
  5. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: S109 Sport Mode Switch

    • Go to next step: If infinite resistance 
  6. All OK.
scientia non olet · About LEMON Manuals