LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Parking Brake System) >> Diagnostic Information and Procedures >> DTC C0558 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC C0558 55 is not set.
    • If DTC C0558 55 is set 
    1. Program the K83 Parking Brake Control Module.
    2. Ignition ON.
    3. Apply and release the park brake.
    4. Verify the DTC is not set.
      • If the DTC is set, replace the K83 Parking Brake Control Module.
      • Go to next step: If the DTC is not set
    5. All OK.
    • Go to next step: If DTC C0558 55 is not set 
  3. Verify the scan tool Park Brake Cable Position parameter is less than 1251 counts.
    • If 1251 counts or greater 
    1. Verify the park brake cable is connected properly. Refer to Park Brake System Diagnosis 
    2. Check park brake pads for excessive wear. Refer to Disc Brake System Diagnosis
    • Go to next step: If less than 1251 counts 
  4. All OK.
scientia non olet · About LEMON Manuals