LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Disc Brake System) >> Repair Instructions >> Rear Brake Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .
  4. GM2027694
    CAUTION:

    Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

    Remove the wheel speed sensor bolt (1).

  5. Remove the wheel speed sensor (2).
  6. GM2027695

    Remove and DISCARD the wheel bearing/hub mounting bolts (1).

  7. GM2027698

    Remove the wheel bearing/hub assembly (2) and rear brake shield (1) from the rear axle assembly.

scientia non olet · About LEMON Manuals