LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Disc Brake System) >> Repair Instructions >> Rear Brake Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the CH-42450-A  kit, thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
  2. Using the CH-41013  kit, thoroughly clean any rust or corrosion from the mating surface and mounting surface of the brake rotor.
  3. Inspect the mating surfaces of the hub/axle flange and the rotor to ensure that there are no foreign particles or debris remaining.
  4. GM2028360

    Install the brake rotor (1) to the hub/axle flange.

    5. CAUTION:

    Refer to Fastener Caution .

  5. Install rear brake rotor bolt (2) and tighten to 9 N.m (80 lb in).
  6. Install the brake caliper and the caliper mounting bracket assembly to the steering knuckle. Refer to Rear Brake Caliper Bracket Replacement .
  7. If the brake rotor was removed and installed as part of a brake system repair, measure the assembled lateral run out (LRO) of the brake rotor to ensure optimum performance of the disc brakes. Refer to Brake Rotor Assembled Lateral Runout Measurement .
    8. NOTE:

    Always replace disc brake pads in axle sets.

  8. Replace the rear disc brake pads. Refer to Rear Disc Brake Pads Replacement .
  9. Tension the parking brake cable. For electric parking brake, refer to Parking Brake Cable Adjuster Enabling , for mechanical parking brake, refer to Parking Brake Adjustment .
scientia non olet · About LEMON Manuals