LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Disc Brake System) >> Repair Instructions >> Rear Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2027665

    Install the brake caliper bracket.

    2. WARNING:

    Refer to Torque-to-Yield Fastener Warning .

    CAUTION:

    This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur.

    CAUTION:

    Refer to Fastener Caution .

  2. Install the NEW brake caliper mounting bracket bolts (1) and tighten a first pass to 100 N.m (74 lb ft).
  3. Tighten the NEW brake caliper mounting bracket bolts (1) a final pass to an additional 60 - 75 degrees, using the EN-45059  meter.
  4. GM2027655

    Install the brake pad retainers (2) to the brake caliper bracket (3).

  5. Install the brake pads (1) to the brake caliper bracket (3).
  6. Install the brake caliper. Refer to Rear Brake Caliper Replacement .
  7. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
  9. Pump the brake pedal 2-3 times in order to seat the rear disc brake pads to the rotor.
scientia non olet · About LEMON Manuals