LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Automatic Transmission - 6T45 (MH7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Lift Plate and Holding Fixture Removal

Lift Plate and Holding Fixture Removal

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
GM1891449
Callout Component Name
1 Transmission Case
WARNING:

Handle with care, the transmission assembly weighs over 83 Kg (183 lbs). Bodily injury could occur if not handled properly.

CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install DT-47811-A  Transmission Lift Plate.
  2. Tighten bolts and nut to 12 N.m (106 lb in).
  3. Remove lock pin from DT-46625  Transmission Holding Fixture.
  4. Raise the transmission with an overhead hoist in order to remove the DT-46625  Transmission Holding Fixture.
  5. Lower the transmission assembly onto the transmission jack in order to remove the DT-47811-A  Transmission Lift Plate.
NOTE:

Only 2 bolt holes on the lift plate will align with the bosses on the transmission case. This is sufficient for lifting the transmission to remove the holding fixture.

Special Tools

  • DT-3289-20  Holding Fixture
  • DT-46625  Transmission Holding Fixture
  • DT-46625-10  Transmission Holding Fixture Adapter
  • DT-47811-A  Transmission Lift Plate

For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals