LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Fascia Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tail lamps. Refer to Tail Lamp Replacement .
  3. GM2949019

    Remove 4 lower rear bumper fascia retainers (1).

  4. Remove 2 rear bumper fascia bolts (2).
  5. GM2949018

    Remove 4 rear wheelhouse liner bolts (1) - left side.

  6. Remove 4 rear wheelhouse liner bolts (1) - right side.
  7. GM2949020

    Pull the rear bumper fascia (1) carefully outward and use a plastic tool in order to release the retaining tabs from the rear bumper fascia outer guides. Use care when removing the fascia. Fascia might rip apart if forced.

  8. Disconnect any electrical connectors.
  9. GM2949021

    With the aid of an assistant remove the rear bumper fascia (1).

scientia non olet · About LEMON Manuals