LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Bumpers And Fascias) >> Repair Instructions >> Front Bumper Impact Bar Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2190879

    Position the front bumper impact bar (1) on the vehicle.

  2. GM2027923
    CAUTION:

    Refer to Fastener Caution .

    Install the 8 front bumper impact bar bolts (1) and tighten to 110 N.m (81 lb ft).

    NOTE:

    Use only the original front bumper impact bar bolts. Replace bolts if damaged.

  3. Apply anti-corrosion materials to the repair area, as necessary.
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals