LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Fender Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4421951

    Check the front fender application foil. If not equipped or damaged, install or replace the front fender application foil.

  2. GM4421950

    Install the front fender bolts - upper (1).

    3. CAUTION:

    Refer to Fastener Caution .

  3. Tighten the front fender bolts - upper to 9 N.m (80 lb in)
  4. GM4421949

    Install the front fender bolts - front (1).

  5. Tighten the front fender bolts - front to 9 N.m (80 lb in)
  6. GM4421948

    Install the front fender bolts - lower (1).

  7. Tighten the front fender bolts - lower to 9 N.m (80 lb in)
  8. GM4421947

    Tighten the front fender bolts - rear to 9 N.m (80 lb in)

  9. GM4421946

    Tighten the front fender bolts - rear upper to 9 N.m (80 lb in)

  10. Body Hinge Pillar Lower Insulator Replacement 
  11. Front Wheelhouse Liner Replacement
  12. Front Bumper Fascia Guide Replacement (Inner)Front Bumper Fascia Guide Replacement (Outer)
  13. Headlamp Replacement
  14. Front Bumper Fascia Replacement
scientia non olet · About LEMON Manuals