Adjustment Axes
| Callout | Component Name |
|---|---|
| X | Horizontal Adjustment (driving direction) |
| Y | Vertical Adjustment (depth direction) |
| Z | Horizontal and Vertical Adjustment (elevating direction) |
| Front Side Door Window | Quarter Window | |||
|---|---|---|---|---|
| Measurement Point 1 115 mm |
Measurement Point 2 60 mm |
Measurement Point 3 80 mm |
Measurement Point 4 200 mm |
|
| TOL | 4.5 mm -0.5 mm/ +1.5 mm | 7.5 mm ±1.5 mm | 7.5 mm ±1.5 mm | 14 mm ±2 mm |
| MAX | 6.0 mm | 9 mm | 9 mm | 16 mm |
| MIN | 4.0 mm | 6 mm | 6 mm | 12 mm |
- In case that the side windows of one complete side, or all side windows do not match, please check first folding top position. Refer to Folding Top Adjustment (With BO-51074-NA Remove/Install and Adjustment Set)Folding Top Adjustment (Without BO-51074-NA Remove/Install and Adjustment Set) .
- Open the folding top.
Mark the measurement point 1 (a) 115 mm from window frame as shown in the graphic.
Mark the measurement point 2 (b) 60 mm from the right upper corner from window glass as shown in the graphic.
Mark the measurement point 3 (c) 80 mm from window frame rubber.
Mark the measurement point 4 (d) 200 mm from the right lower corner as shown in the graphic.
- Close the folding top.
Mark the 4 values for the front side door window and quarter window as shown in the graphic (1).
- Open the folding top.
Measure the values on the 4 measurement point (1) as shown in the graphic and compare them with the values in the table.
Measure the vertical alignment (a) 2.5 mm between the front side door window upper edge (1) and quarter window upper edge (2).
Measure the horizontal alignment (b) 12.5 mm ± 2 mm between the right upper corner of front side door window (1) and the left upper corner of quarter window (2).
- When the values are not in the tolerance mass, mark the right values on the tape and adjust the relevant window. Refer to Front Side Door Window Adjustment , or Quarter Window Adjustment to adjust the windows.