LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Fixed And MOVEABLE Window System) >> Diagnostic Information and Procedures >> Rear Window Defogger Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter: Rear Defogger Switch = Off
    • If not the specified state 

      Test or replace the component: A26 HVAC Controls

    • Go to next step: If the specified state 
  3. Operate the component: Rear Defogger Switch - Pressed

    Verify the scan tool parameter: Rear Defogger Switch = On

    • If not the specified state 

      Test or replace the component: A26 HVAC Controls

    • Go to next step: If the specified state 
  4. Perform the scan tool control function: Rear Defogger - On and Off

    Verify the component turns On and Off: E18 Rear Defogger Grid

    • If the component does not turn On and Off 

      Refer to: Circuit/System Testing

    • Go to next step: If the component turns On and Off 
  5. All OK.
scientia non olet · About LEMON Manuals