Engine Support Fixture

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
Preliminary Procedure To gain access for the engine support fixture installation remove the wiring harness from the front compartment upper side rail. Special Tools EN-43405 Engine Support Fixture Adapter EN-28467-1A Cross Bracket EN-28467-5A Strut Tower Support Assembly EN-28467-8A Hook Assembly EN-28467-2A Radiator Tube Shelf Assembly Equivalent regional tools:Special Tools
1	Engine Support Fixture Adapter Leg (Qty: 2) Procedure Install the bracket to fender frame. Do not install on top of fender lip. Install EN-43405 - 1 Engine Support Fixture Adapter to the left side. Install EN-43405 - 2 Engine Support Fixture Adapter to the right side.
2	Main Support Beam
3	Cross Bracket[2x]
4	Strut Tower Support Assembly (Qty: 2) Procedure Adjust the length of the strut tower support assembly.
5	Radiator Tube Shelf Assembly (Qty: 2)
6	Hook Assembly (Qty: 2)