LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical - 1.6L (LWC)) >> Repair Instructions - On Vehicle >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2191341

    Install the engine mount (5).

  2. Install the 2 engine mount to body bolts (2).
  3. Install the engine mount nut (1).
  4. Install the 3 NEW engine mount to engine mount bracket bolts (3) and the 3 washers (4).
    5. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  5. Tighten the 2 engine mount to body bolts (2) and the engine mount nut (1) to 62 N.m (46 lb ft).
  6. Tighten the 3 NEW engine mount to engine mount bracket bolts (3) a first pass to 50 N.m (37 lb ft).
  7. Tighten the 3 NEW engine mount to engine mount bracket bolts a final pass to 60 - 75 degrees, using the EN-45059  meter.
  8. GM3213232

    Remove the engine lifter (1) from the right engine lift bracket.

  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  10. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
scientia non olet · About LEMON Manuals