Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Slide a NEW crankshaft rear oil seal (2) over the EN-51151-1 installer (1) onto the EN-51151-2 installer (3).
Remove the EN-51151-1 installer (1).
Install the EN-523-1 handle (3) to the EN-51151-2 installer (2).
Install the crankshaft rear oil seal ring using the EN-51151-2 installer (3) along with the EN-523-1 handle (1) to the crankshaft rear oil seal housing (2).
Clean the crankshaft rear oil seal housing sealing surfaces.
NOTE:
The complete installation procedure of the crankshaft rear oil seal housing must be fitted within 10 minutes of applying the sealing compound. DO NOT coat sealing compound into the crankshaft rear oil seal housing bolt bores and threads.

Apply approximately a 3.0 mm (0.12 in) thick bead of sealant (1) to the crankshaft rear oil seal housing (2). Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.
Apply additional sealant (1, 2) to the transitions between the cylinder block and the lower crankcase in the shown area.
Install the crankshaft rear oil seal housing (1) along with the crankshaft rear oil seal.
CAUTION:
Fastener Caution

Install the 4 long crankshaft rear oil seal housing bolts (2) and tighten to 10 N.m (89 lb in).
Install the 6 short crankshaft rear oil seal housing bolts (1) and tighten to 10 N.m (89 lb in).
Automatic Transmission Flex Plate Replacement - Install