LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical - 1.6L (LWC)) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2968031

    Install the NEW crankshaft front oil seal (1) to the EN-51152  installer (2).

  2. GM2968030

    Using the EN-51152  installer (1), install the crankshaft front oil seal to the engine front cover.

  3. Install the crankshaft balancer absorber bolt (2) and tighten.
  4. Remove the bolt (2) and EN-51152  installer (1).
  5. GM3011801

    Ensure that the crankshaft front oil seal (1) flushes with the engine front cover (2).

  6. Install the crankshaft balancer absorber. Refer to Crankshaft Balancer Absorber Replacement .
  7. Remove the collecting basin.
  8. Check and correct the engine oil level. For engine oil specifications, refer to Engine Mechanical Specifications .
scientia non olet · About LEMON Manuals