LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical - 1.6L (LWC)) >> Repair Instructions - Off Vehicle >> Turbocharger Oil Feed Pipe Installation

Turbocharger Oil Feed Pipe Installation

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3405247

    The clamp (1) from the turbocharger oil feed pipe fitting is pre-installed.

  2. GM3405245

    Install 2 NEW turbocharger oil pipe fitting seal rings (2)

    3. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    The turbocharger oil feed pipe fittings are not reusable.

    NOTE:

    Do not remove the turbocharger oil feed pipe fitting clamps.

  3. Install a NEW turbocharger oil feed pipe fitting (1) to the turbocharger and tighten to 24 N.m (89 lb ft).
  4. Install a NEW turbocharger oil feed pipe fitting (1) to the oil cooler housing and tighten to 24 N.m (89 lb ft).
  5. GM3405249

    Clip in the turbocharger oil feed pipe (1) to the turbocharger oil feed pipe fittings (2).

  6. Pull back on pipe to be sure it is seated correctly in the clamps.
scientia non olet · About LEMON Manuals