Drive Belt Installation

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-6349 Locking Pin

For equivalent regional tools, refer to Special Tools .

Install the drive belt (1).
Release tension from the tensioner by rotating the upper drive belt tensioner bolt (1) counterclockwise.

NOTE:

Let the tensioner slide back slowly.

Remove EN-6349 pin (2).
Check the routing of the drive belt and make sure, that the drive belt is aligned properly to the shown components.