LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical - 1.6L (LWC)) >> Repair Instructions - Off Vehicle >> Cylinder Head Disassemble

Cylinder Head Disassemble

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

Equivalent regional tools:Special Tools 

  1. GM2678147

    Install the EN-50717-2  assembly (1) to the EN-8062  compressor (4).

  2. Install the EN-8062-5  adapter (3) to the EN-8062  compressor.
  3. Install the compressor assembly to the cylinder head, so that the adapter (5) of the EN-50717-2  assembly (1) contacts the valve spring retainer properly and the EN-8062-5  adapter (3) contacts the valve disc (2). Prefix the EN-8062  compressor (4).
  4. GM2678153
    WARNING:

    Valve springs can be tightly compressed. Use care when removing the retainers and plugs. Personal injury could result.

    Apply pressure to the EN-50717-2  assembly to push down the vale spring retainer (1) and compress the valve spring (3) until the valve keys (2) are free from tension. Carefully remove the valve keys.

  5. GM2678154

    Slowly and carefully loosen the EN-50717-2  assembly until the valve spring is entirely expanded.

  6. Remove the compressor assembly from the cylinder head.
  7. Remove the valve spring retainer (1) and the valve spring (3).
  8. Remove and DISCARD the valve stem oil seal (4), using the EN-840  pliers (2).
  9. Remove the valve (5).
    10. NOTE:

    Ensure that the valve train components are kept together and identified in order for proper installation in their original position.

  10. Repeat the procedure with the remaining valves.
  11. In case of re-using the cylinder head, refer to Cylinder Head Cleaning and Inspection .
scientia non olet · About LEMON Manuals