LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Mechanical - 1.6L (LWC)) >> Diagnostic Information and Procedures >> Coolant in Combustion Chamber

Coolant in Combustion Chamber

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Cause Correction
DEFINITION: Excessive white smoke and/or coolant type odor coming from the exhaust pipe may indicate coolant in the combustion chamber. Low coolant levels, an inoperative cooling fan, or a faulty thermostat may lead to an overheating condition which may cause engine component damage.
  1. A slower than normal cranking speed may indicate coolant entering the combustion chamber. Refer to Engine Will Not Crank - Crankshaft Will Not Rotate .
  2. Remove the spark plugs and inspect for spark plugs saturated by coolant or coolant in the cylinder bore.
  3. Inspect by performing a cylinder leak-down test. During this test, excessive air bubbles within the coolant may indicate a faulty gasket or damaged component.
  4. Inspect by performing a cylinder compression test. Two cylinders side-by-side on the engine block, with low compression, may indicate a failed cylinder head gasket. Refer to Engine Compression Test .
Faulty cylinder head gasket Replace the head gasket and components as required. Refer to Cylinder Head Cleaning and Inspection , and Cylinder Head Replacement .
Warped cylinder head Replace the cylinder head and gasket. Refer to Cylinder Head Replacement .
Cracked cylinder head Replace the cylinder head and gasket. Refer to Cylinder Head Replacement .
Cracked cylinder liner Replace the components as required.
Cylinder head or block porosity Replace the components as required.
scientia non olet · About LEMON Manuals