Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

In case of reuse of the exhaust parts, check the exhaust pipes at the separating sets for the following conditions:
- Roundness of the exhaust pipe, any deformation in the range of the double-clamp must be eliminated.
- Burrs inside and outside the exhaust pipe at the cutting edge, use a file to eliminate.
- Rust at the exhaust pipe outside, use sandpaper to eliminate.
Install the exhaust tail pipe hanger bracket (2) to the exhaust tail pipe (4).

NOTE:

A second technician is required.

Install the exhaust tail pipe (4) to the exhaust rear muffler (1).

CAUTION:

Refer to Fastener Caution .

Install the exhaust tail pipe hanger bracket bolt (3) and tighten to 22 N.m (16 lb ft).
Install the exhaust tail pipe clamp (5) and tighten loosely.
Position the exhaust tail pipe (4).
Tighten the exhaust tail pipe clamp (5) to 30 N.m (22 lb ft).
Install the underbody brace - rear V-rod. Refer to Underbody Brace Replacement - Rear V-Rod .
Lower and unsupport the vehicle.