LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission Cooling System) >> Diagnostic Information and Procedures >> Transmission Fluid Cooler Flow Test and Flushing >> Clean-up

Transmission Fluid Cooler Flow Test and Flushing: Clean-up

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1212328

    Turn the main function switch (2) to the IDLE position and allow the supply vessel pressure to dissipate.

  2. Turn the main power switch (1) to the OFF position.
    3. NOTE:
    • A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.
    • If the fluid in the DT-45096  transmission oil cooling system flush and flow test tool is different than what is used in the transmission, use compressed air to blow the residual transmission fluid out of the oil cooler and lines.
  3. Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
  4. GM1212333

    Disconnect the air supply hose from DT-45096  flush and flow test tool.

  5. Remove the DT-45096 - 50  adapters.
  6. Dispose of the waste automatic transmission fluid in accordance with all applicable federal, state, and local requirements.
scientia non olet · About LEMON Manuals