LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Cooling System) >> Repair Instructions >> Radiator Surge Tank Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2189555

    Install the radiator surge tank (1) and clip into the bracket (3).

  2. Connect coolant level sensor wiring harness plug (4).
  3. Install radiator surge tank clip (2).
  4. Install the radiator surge tank engine hose (5), install the clamp.
  5. Install the engine coolant air bleed hose (6), install the clamp.
  6. GM2814202

    Position the voltage distribution unit on the battery.

    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the voltage distribution terminals and tighten the 2 nuts to 12 N.m (106 lb in).
  8. Connect the positive terminal pole and tighten the nut to 4.5 N.m (40 lb in).
  9. Refill the radiator surge tank with the coolant fluid, which has been drained out before.
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals