Component Testing
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Static Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector: E41 Engine Coolant Thermostat Heater
- Test for 10 to 70 ohms between the test points: Ignition terminal 2 & Control terminal 1
- If not between 10 and 70 ohms
Replace the component: E41 Engine Coolant Thermostat Heater
- Go to next step: If between 10 and 70 ohms
- If not between 10 and 70 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: E41 Engine Coolant Thermostat Heater
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.