Circuit/System Description

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

The engine cooling fan system is composed of one cooling fan, a series of 3 relays, the engine control module (ECM), and the associated wiring. The cooling fan motor assembly includes two resistors. This combination of components enables the ECM to operate the cooling fan at 3 speeds using two fan control circuits. The underhood fuse block supplies the cooling fan relays with B+ at the switch side, and ignition voltage at the coil side of the relays through separate fuses. When the cooling fan is commanded ON, the ECM grounds the appropriate relay control circuit, which energizes the relay coil. The magnetic field, created within the relay by the energized relay coil, overcomes the spring tension of the bi-metal switch armature causing the relay switch to close. When the relay switch closes, B+ is supplied to the cooling fan motor through the relay controlled output circuit, causing the cooling fan motor to operate. A dedicated ground is supplied to the cooling motor to complete the circuit.