Fastener Specifications
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Front Wheel Drive Shaft Retaining Rings |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Shaft Inner and Outer Joint Boot Clamps | 25 N.m (18 lb ft) |
| Wheel Drive Shaft Nut | |
|
150 N.m (111 lb ft) |
|
Loosen by 45 Degrees |
|
250 N.m (184 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Intermediate Shaft Bearing Bolt | 22 N.m (16 lb ft) |
| Front Wheel Drive Intermediate Shaft Bracket Lower Bolt | 22 N.m (16 lb ft) |
| Front Wheel Drive Intermediate Shaft Bracket Upper Bolt | 22 N.m (16 lb ft) |