LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Wheel Drive Shafts) >> Repair Instructions >> Front Wheel Drive Shaft Outer Joint Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM174601

    Install a NEW retaining ring to the front wheel drive shaft. Start to pull the ring from the upper driveshaft end down to the ring groove.

  2. GM2008315

    Install the front wheel drive shaft boot (1) to the front wheel drive shaft (2).

  3. GM2008345

    Install the joint (1) to the wheel drive shaft using a wooden block and a hammer. Make sure that the retaining ring engages audibly.

  4. GM174625

    Place approximately half of the grease delivered with the service kit inside the joint and fill the boot with the remaining grease.

  5. GM3213073

    Position the boot to the grooves in the joint and the wheel drive shaft.

  6. Install a NEW front wheel drive shaft boot (2) and clamp (1).
  7. GM2027983

    Crimp the clamp using the CH-804  tensioner (1) and a torque wrench. Tighten the tool to 25 N.m (18 lb ft).

  8. Remove all excess grease which leaked out.
  9. Install the front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Left Side , or Front Wheel Drive Shaft Replacement - Right Side .
scientia non olet · About LEMON Manuals