LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Wheel Drive Shafts) >> Repair Instructions >> Front Wheel Drive Intermediate Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4248285

    Install a NEW inner orange sealing ring (1) to the rear notch in the front wheel drive intermediate shaft.

  2. Install a NEW outer black sealing ring (2) to the front notch in the front wheel drive intermediate shaft.
  3. GM4247079
    CAUTION:

    DT-6332/ DT-51504 or equivalent must be installed into the front wheel drive shaft oil seal prior to removing and installing the front wheel drive shaft. Failure to use the DT-6332/ DT-51504 may cause the spline of the front wheel drive shaft to cut the front wheel drive shaft oil seal. Damage to the front wheel drive shaft oil seal will result in lubricant leaks.

    Install the DT-6332  seal protector (1) into the differential output shaft seal.

  4. GM3952841

    Intermediate Shaft(1) - Install

  5. GM3952843

    DT-6332  Seal Protector (1) - Remove

  6. Install the wheel drive shaft into the differential until the retaining ring is fully seated.
  7. Confirm that the front wheel drive shaft retaining ring is properly seated by grasping the inner housing and pulling the inner housing outward.
  8. GM3952842

    Bolt(2)@Intermediate Shaft Bearing Flange(1) - Install and tighten[3x] 22 N.m 16 (lb ft)

  9. Carefully install the wheel drive shaft into the intermediate shaft. Front Wheel Drive Shaft Replacement - Right Side 
scientia non olet · About LEMON Manuals