LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Oil Pump Flow Control Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the oil pump flow control valve sealing surface at the engine block.
  2. GM3216214

    Install a NEW oil pump flow control valve seal (1).

  3. Install the oil pump flow control valve (2).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the 3 oil pump flow control valve bolts (3) and tighten to 10 N.m (89 lb in).
  5. Connect the oil pump flow control valve wiring harness plug.
  6. Install the generator. Refer to Generator Replacement .
  7. Check and correct engine oil. Refer to Engine Mechanical Specifications .
scientia non olet · About LEMON Manuals