LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Fuel Tank Baffle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2834329
    NOTE:

    Perform the steps 1-3 only when the fuel tank baffles are not transferred from the OLD to the NEW tank.

    Tension the fuel tank baffle (1) completely by pressing it down.

  2. Push the lug (2) toward the baffle and hold it.
  3. Release tension from the fuel tank baffle (1) until the lug (2) engages safely.
  4. GM2834327

    Install the baffles (1) one by one.

  5. GM2834331

    Press the fuel tank baffle together until the lug (1) becomes unlocked.

  6. Release tension slowly from the fuel tank baffle and let the baffle engage safely in the installation site.
  7. GM2834328

    Check the proper seat of the fuel tank baffle at the fuel tank installation sites (1). Use a mirror if necessary.

  8. Repeat steps 1 to 7 to install the other baffle.
  9. Install the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
  10. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals