LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Fuel Injection Fuel Feed Front Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2914281

    Install the fuel injection fuel feed pipe (3) to the fuel injection fuel rail (1) and to the fuel injection pump (6).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 nuts (2, 5) and tighten to 30 N.m (22 lb ft).
  3. Install the fuel injection fuel feed pipe bracket bolt (4) and tighten to 10 N.m (89 lb in).
  4. Charge Air Cooler Outlet Air Hose Replacement  - Install
  5. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection .
    6. WARNING:

    Fuel escapes - observe safety measures and national legislation. Failure to comply could result in personal injury.

    WARNING:

    Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.

    NOTE:

    Ensure that all work at the engine is finished.

  6. Perform a fuel injection system leak test.
    1. Start the engine.
    2. Check the fuel system for escaping fuel.
scientia non olet · About LEMON Manuals