LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Fuel Feed Pipe Replacement - Underbody >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the CH-807  plugs from fuel feed tank pipe and fuel feed pipe.
  2. GM2834311

    Install and position the fuel feed pipe-underbody (3).

  3. Connect the fuel tank feed pipe connector (1) to the fuel feed pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel pressure sensor wiring harness plug (2).
  5. GM2191622

    Close the 4 fuel pipe clips (2).

  6. GM4230996

    Install the fuel feed pipe-underbody (1) to the lower bulkhead clip (2).

  7. Close the lower bulkhead clip (2).
  8. Drivetrain and Front Suspension Frame Replacement - Remove
  9. GM4230995

    Install the fuel feed pipe-underbody (1) to the upper bulkhead clip.

  10. Close the upper bulk head clip (3).
  11. Connect the fuel feed front pipe (2) to the fuel feed pipe-underbody (1). Refer to Metal Collar Quick Connect Fitting Service .
  12. Engine Sight Shield Replacement - Install
  13. Battery Negative Cable Disconnection and Connection - Connect
scientia non olet · About LEMON Manuals