LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Fuel Vapors in Evaporative Emission Components Warning .

WARNING:

Refer to Diesel/Gasoline Vapors Warning .

WARNING:

Refer to Safety Goggles and Fuel Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the underbody brace - rear V-rod. Refer to Underbody Brace Replacement - Rear V-Rod .
  3. GM2373346
    NOTE:

    Do not remove the fuel tank filler hose when the fuel contents in the fuel tank is over the half filled with fuel.

    If the fuel level is over half filled, refer to Fuel Tank Draining .

  4. Remove the clamp (2).
  5. Remove the fuel tank filler hose (3) from the fuel tank filler pipe (1).
  6. Disconnect the fuel tank filler vent pipe (4). Refer to Plastic Collar Quick Connect Fitting Service .
  7. Unclip the fuel feed pipe and the fuel vent pipe from the rear bracket clip at the underbody.
  8. Place a suitable adjustable jack under the fuel tank.
  9. GM2373337

    Remove the 2 fuel tank strap bolts (3) with the fuel tank strap bolt retainers (2).

  10. Remove the 2 fuel tank strap bolts (5) with the fuel tank strap bolt retainers (6).
  11. Remove the 2 fuel tank straps (4).
    12. NOTE:

    Pay attention to other parts like pipes or hoses that are installed at the fuel tank.

  12. Lower the fuel tank only a little bit, when its not possible to remove the evaporative emission canister easily. Remove the fuel tank completely, refer to Fuel Tank Replacement .
    13. NOTE:

    A second technician is required.

  13. Lower the fuel tank to a height where its able to remove the evaporative emission canister easily.
  14. GM2028245

    Disconnect the fuel tank vent pipe (2).

  15. Disconnect the evaporative emission canister purge pipe (4). Refer to Plastic Collar Quick Connect Fitting Service .
  16. Remove the evaporative emission canister (1) from the evaporative emission canister bracket (3).
scientia non olet · About LEMON Manuals