LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2028245

    Install the evaporative emission canister (1) to the evaporative emission canister bracket (3).

  2. Connect the evaporative emission canister purge pipe (4). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Connect the fuel tank vent pipe (2).
    4. NOTE:

    A second technician is required.

  4. Raise the fuel tank to its original position.
  5. GM2373337

    Pre-install the 4 fuel tank strap bolts (3, 5) with the fuel tank strap bolt retainers (2, 6) at the fuel tank straps (4).

  6. Install the 2 fuel tank straps (4).
    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the 4 fuel tank strap bolts (3, 5) and tighten to 20 N.m (15 lb ft).
  8. Remove the adjustable jack from the fuel tank.
  9. Clip the fuel feed pipe and the fuel vent pipe into the rear bracket clip at the underbody.
  10. GM2373346

    Connect the fuel tank filler vent pipe (4). Refer to Plastic Collar Quick Connect Fitting Service .

  11. Install the fuel tank filler hose (3) to the fuel tank filler pipe (1).
  12. Install the clamp (2).
  13. Install the underbody brace - rear V-rod. Refer to Underbody Brace Replacement - Rear V-Rod
  14. Lower the vehicle.
scientia non olet · About LEMON Manuals