Engine Oil Pressure Sensor Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
Preliminary Procedures Air Cleaner Assembly - Remove - Air Cleaner Assembly Replacement . Engine Sight Shield - Remove - Engine Sight Shield Replacement . Disconnect the electrical connector.
1	Engine Oil Pressure Sensor CAUTION: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur. CAUTION: Refer to Fastener Caution . Procedure Clean the threaded hole. Connect the electrical connector. Engine Sight Shield - Install - Engine Sight Shield Replacement . Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement . Tighten 35 N.m (26 lb ft)

Callout

Component Name

Preliminary Procedures

Air Cleaner Assembly - Remove - Air Cleaner Assembly Replacement .
Engine Sight Shield - Remove - Engine Sight Shield Replacement .
Disconnect the electrical connector.

Engine Oil Pressure Sensor

CAUTION:

This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur.

CAUTION:

Refer to Fastener Caution .

Procedure

Clean the threaded hole.
Connect the electrical connector.
Engine Sight Shield - Install - Engine Sight Shield Replacement .
Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement .

Tighten
35 N.m (26 lb ft)