LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Charge Air Bypass Valve Replacement (Intake) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. GM2968087
    CAUTION:

    In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.

    Remove the wiring harness bracket bolt (2).

  4. Remove the wiring harness bracket (1) from the engine block.
  5. GM2968088

    Disconnect the charge air bypass valve wiring harness plug (6).

  6. Remove the 2 charge air bypass valve hose clamps (4, 7).
  7. Remove the 3 charge air bypass valve hoses (1, 3, 5).
  8. Unclip the retainer clips (arrows) and remove charge air bypass valve (2).
scientia non olet · About LEMON Manuals