LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Charge Air Bypass Valve Replacement (Intake) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2968088

    Install charge air bypass valve (2).

  2. Install the 3 charge air bypass valve hoses (1, 3, 5).
  3. Install the 2 charge air bypass valve hose clamps (4, 7).
  4. Connect the charge air bypass valve wiring harness plug (6).
  5. GM2968087

    Install the wiring harness bracket (1) to the engine block.

    6. CAUTION:

    Refer to Fastener Caution .

  6. Install the wiring harness bracket bolt (2) to 22 N.m (16 lb ft).
  7. Lower and unsupported the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals