LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Charge Air Bypass Valve Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  3. GM2906658
    CAUTION:

    In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.

    Remove the charge air bypass valve hose clamp (2).

  4. Remove the charge air bypass valve hose (3) from the charge air bypass valve - turbocharger.
  5. Remove the 2 retainer clips (1).
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  8. GM2906659

    Remove the charge air bypass valve hose clamp (2).

  9. Unclip the charge air bypass valve hose from the 2 clips (3).
  10. Remove the charge air bypass valve hose (1) from the charge air bypass valve - intake manifold.
  11. Lower the vehicle.
  12. Remove the charge air bypass valve hose.
scientia non olet · About LEMON Manuals