LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Valve Solenoid Replacement - Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3137488

    Install the camshaft position actuator solenoid valve solenoid seal (1).

  2. Install the camshaft position actuator solenoid valve solenoid (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the camshaft position actuator solenoid valve solenoid bolt (3) and tighten to 10 N.m (89 lb in).
  4. Connect the camshaft position actuator solenoid valve solenoid wiring harness plug.
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
scientia non olet · About LEMON Manuals