Starter Replacement

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Disconnect the negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection . Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . If equipped, remove the engine shield. Refer to Engine Shield Replacement .
1	Starter and Generator Positive Cable Nut CAUTION: Refer to Fastener Caution . Tighten 12.5 N.m (111 lb in)
2	Starter and Generator Positive Cable
3	Starter Ground Cable Nut Tighten 20 N.m (15 lb ft)
4	Starter Ground Cable
5	Starter Stud Tighten 22 N.m (16 lb ft)
6	Starter Bolt Tighten 22 N.m (16 lb ft)
7	Starter