Installation Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Install the battery tray (2).
- Install the 3 battery tray bolts (1) and tighten to 15 N.m (11 lb ft).
Clip in the battery current sensor (1) to the battery tray.
- If equipped, clip in the radiator surge tank engine hose to the battery tray.
- Install battery. Refer to Battery Replacement .
- Clip in all wiring harness at the battery tray.
- Clip in the engine control module bracket to the battery tray.
- Close the hood.
CAUTION:
Refer to Fastener Caution .