LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> Starter Noise Diagnosis >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flywheel inspection cover.
  2. Inspect the flywheel for loose flywheel bolts.
    • If there are loose flywheel bolts 

      Tighten the flywheel bolts, refer to Fastener Tightening Specifications.

    • Go to next step: If there are no loose flywheel bolts 
  3. Inspect the flywheel for missing or chipped gear teeth
    • If there are chipped or missing gear teeth 

      Replace the flywheel.

    • Go to next step: If there are no chipped or missing gear teeth 
  4. Inspect the bell housing for debris.
    • If there is debris in the bell housing 

      Remove the debris.

    • Go to next step: If there is no debris in the bell housing 
  5. Inspect the flywheel for bending.
    • If the flywheel is bent 

      Replace the flywheel

    • Go to next step: If the flywheel is not bent 
  6. Replace the starter.
scientia non olet · About LEMON Manuals