LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Lighting System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B1480 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, scan tool disconnected, all doors closed, all accessories OFF, disconnect the harness connectors at the following components.
    • E37F Dome/Reading Lamps - Front
    • E27 Instrument Panel Compartment Lamp
    • A3L Sunshade - Left
    • A3R Sunshade - Right
  2. Test for less than 15 Ω between the appropriate ground circuit terminal listed below and ground.
    • E37F Dome/Reading Lamps - Front terminal 6
    • E27 Instrument Panel Compartment Lamp terminal 2
    • A3L Sunshade - Left terminal B
    • A3R Sunshade - Right terminal B
    • If 15 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • Go to next step: If less than 15 Ω 
  3. Connect a test lamp between the appropriate control circuit terminal listed below and ground.
    • E37F Dome/Reading Lamps - Front terminal 1
    • E27 Instrument Panel Compartment Lamp terminal 1
    • A3L Sunshade - Left terminal A
    • A3R Sunshade - Right terminal A
  4. Verify the test lamp turns ON and OFF when commanding the Inadvertent Load ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X7 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X7 harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit terminal and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • Go to next step: If the test lamp turns ON and OFF 
  5. Test or replace the appropriate courtesy lamp.
scientia non olet · About LEMON Manuals