LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Lighting System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B1461 or B1462 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, exterior lamps OFF, disconnect the harness connector at the appropriate E13 Headlamp Assembly.
  2. Test for less than 10 Ω between the ground circuit terminal 8 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • Go to next step: If less than 10 Ω 
  3. Ignition ON.
  4. Verify a test lamp illuminates between the B+ circuit terminal 6 and ground.
    • If the test lamp does not illuminate 
    1. Ignition OFF, disconnect the X1 harness connector at the X50A Fuse Block - Underhood.
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the X50A Fuse Block - Underhood.
    • Go to next step: If the test lamp illuminates 
  5. Test or replace the K26 Headlamp Control Module.
  6. Ignition ON.
  7. Verify the appropriate headlamp operates to the LEFT and RIGHT positions when commanding the appropriate Headlamp Horizontal Motor control LEFT and RIGHT with a scan tool.
    • If the appropriate headlamp does not operate LEFT and RIGHT 

      Test or replace the E13 Headlamp Assembly.

    • Go to next step: If appropriate headlamp operates LEFT and RIGHT 
  8. All OK.
scientia non olet · About LEMON Manuals