LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Folding Top) >> Repair Instructions >> Folding Top Multifunction Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3011722

    Push the folding top multifunction control module (1) into the fuse block bracket (3).

  2. GM3011725

    Connect the 7 wiring harness plugs (1) with the folding top multifunction control module.

  3. Flip the fuse block bracket (2) up to its fixing point.
  4. GM3011723
    CAUTION:

    Refer to Fastener Caution .

    Install the 3 fuse block bracket nuts (2).

  5. Connect the wiring harness plug (1).
  6. Program the CRCM. Refer to Control Module References .
  7. GM3011724

    Install the rear seat back armrest hinge bracket (1).

  8. Install the retainer clip (2).
  9. GM2949064

    Install the quarter inner trim finish panel - left side (4).

scientia non olet · About LEMON Manuals